













Polaris General REAR Camera Relocation Kit
$41.99
-
NOTE: IF YOU HAVE A 2016-2019 GENERAL RIDE COMMAND, CHECK TO MAKE SURE YOUR CAMERA HAS A DIAMETER OF 7/8″ IF it does you will need to purchase the Grommet seal to make the camera fit. 2020-2023 you do NOT need this grommet. The grommet seal also works for relocating the front camera to this bracket.
- Description
Description
Want to get the best use out of your Ride Command Camera system? This kit relocates the cameras to a better view angle using our new Rear brackets. The REAR camera gets moved from under the bed to above the bed on the cab for a much more clear rear view. Camera extension wire is needed unless you already have one. It is ran up the C Piller to the roof line from the interior. Camera Extension can be ran down the passenger side cage hole using a metal coat hanger but you will have to cut the harness or depin the connector as it is too big to fit down the channel. Camera Not Included.
NOTE: IF YOU HAVE THE 2016-2018 RIDE COMMAND, POLARIS MAY HAVE USED THE FRONT CAMERA 3/4 DIAMETER ON THE REAR. PLEASE MAKE SURE BEFORE ORDERING THAT YOU HAVE THE 7/8 DIAMETER CAMERA. IF YOU HAVE THE 3/4 DIAMETER YOU CAN PURCHASE A RUBBER GROMMET below TO MAKE THE CAMERA FIT SNUG.
- Satin Black Powder Coating Bracket
- Camera Extension Harness(SELECTABLE OPTION) Is not included unless you select the option
- Rubber Grommet for 3/4 Camera (SELECTABLE OPTION) Is not included unless you select the option
- Fits 2016-2024 Polaris General
- LIMITED LIFETIME WARRANTY ( Made in USA)