Ghozt LED Sequencers v5 28 Channel (SOLD AS EACH)



SKU: GhoZtMod5


Ghozt LED Sequencers v5 28 Channel (SOLD AS EACH)

Professional Installation Recommended!

Note: You will need to purchase the Pickit3 programmer interface to re-program these units yourself.

  • New, larger, version 5 model!
  • Show mode stays in sync for hours longer now!
  • 5 12v inputs, 28 switched ground outputs
  • Sequential turn signals
  • Parking/running lights on/off animation
  • Vehicle on/off animation
  • Looping show mode, triggered by a 12v switch
  • Auto-synchronizing turn signal timing to car’s flasher unit
  • 3 turns, 1 touch feature added to any car
  • Reprogrammable after install! (Simply extend programming pins out of housing)
  • Extremely low power drain while in operation, sleep mode when idle
  • Comes with default programming, or completely customizable using our software!
  • Ultra small form factor!
  • Made in the USA

Minimal experience with retrofitting, soldering, and working with LEDs/resistors required. Headlight/taillight in most cases must be opened to gain direct access to LEDs, to rewire to our sequencer.

  • (5) 12v inputs
  • (28) outputs- switched ground
  • Oscillator to synchronize show mode timing
  • LED Dimming using PWM
  • Output channels can sustain up to 260mA each at 100 degrees C, 380mA at room temp (5.2A total!)
  • Channel output current can be increased using our booster circuit (see our DIY section)
  • Provides full control of LEDs for running lights, sequential turn signals, brakes, car startup/shutdown, and show mode animations
  • Fully programmable animations; build sequences or select from a list of pre-defined animations with our in-house software and have it shipped with your customized animations!
  • On-the-bench re-programming with PICkit3 USB microchip Programmer (optional – $25-50)
  • Ceramic capacitors/automotive grade components for reliability, designed to operate in extreme temperatures

  • (1) v5 Ghozt Sequencer 28 Channel Board


User manual download: TurnSequencer_v5-UserGuide_3Feb2015

Programmer download: PICkit USB microchip Programmer application

Sequence Designer download: